10

During one of our visits at Konza City, Machakos county in Kenya, my team and I encountered a big problem accessing to viable water. Most times we enquired for water, we were handed a bottle of bought water. This for a day or few days would be affordable for some, but for a lifetime of a middle income person, it will be way too much expensive. Of ten people we encountered 8 complained of a proper mechanism to access to viable water. This to us was a very demanding problem, that needed to be sorted out immediately. Majority of the people were unable to conduct income generating activities such as farming because of the nature of the kind of water and its scarcity as well.
Such a scenario demands for an immediate way to solve this problem. Various ways have been put into practice to ensure sustainability of water conservation and management. However most of them have been futile on the aspect of sustainability. As part of our research we also considered to check out of the formal mechanisms put in place to ensure proper acquisition of water, and one of them we saw was tree planting, which was not sustainable at all, also some few piped water was being transported very long distances from the destinations, this however did not solve the immediate needs of the people.We found out that the area has a large body mass of salty water which was not viable for them to conduct any constructive activity. This was hint enough to help us find a way to curb this demanding challenge. Presence of salty water was the first step of our solution.

SOLUTION

We came up with an IOT based system to help curb this problem. Our system entails purification of the salty water through electrolysis, the device is places at an area where the body mass of water is located, it drills for a suitable depth and allow the salty water to flow into it. Various sets of tanks and valves are situated next to it, these tanks acts as to contain the salty water temporarily. A high power source is then connected to each tank, this enable the separation of Chlorine ions from Hydrogen Ions by electrolysis through electrolysis, salt is then separated and allowed to flow from the lower chamber of the tanks, allowing clean water to from to the preceding tanks, the preceding tanks contains various chemicals to remove any remaining impurities. The whole entire process is managed by the action of sensors. Water alkalinity, turbidity and ph are monitored and relayed onto a mobile phone, this then follows a predictive analysis of the data history stored then makes up a decision to increase flow of water in the valves or to decrease its flow. This being a hot prone area, we opted to maximize harnessing of power through solar power, this power availability is almost perfect to provide us with at least 440V constant supply to facilitate faster electrolysis of the salty water.
Being a drought prone area, it was key that the outlet water should be cold and comfortable for consumers to use, so we also coupled our output chamber with cooling tanks, these tanks are managed via our mobile application, the information relayed from it in terms of temperature and humidity are sent to it. This information is key in helping us produce water at optimum states, enabling us to fully manage supply and input of the water from the water bodies.
By the use of natural language processing, we are able to automatically control flow and feeing of the valves to and fro using Voice, one could say “The output water is too hot”, and the system would respond by increasing the speed of the fans and making the tanks provide very cold water. Additional to this system, we have prepared short video tutorials and documents enlighting people on how to conserve water and maintain the optimum state of the green economy.
IBM/OPEN SOURCE TECHNOLOGIES
For a start, we have implemented our project using esp8266 microcontrollers, sensors, transducers and low payload containers to demonstrate our project. Previously we have used Google’s firebase cloud platform to ensure realtimeness of data to-and-fro relay to the mobile. This has proven workable for most cases, whether on a small scale or large scale, however we meet challenges such as change in the fingerprint keys that renders our device not workable, we intend to overcome this problem by moving to IBM bluemix platform.
We use C++ Programming language for our microcontrollers and sensor communication, in some cases we use Python programming language to process neuro-networks for our microcontrollers.

Any feedback conserning this project please?

Comments
  • 2
    I'm interested in the economics of this project. What is your initial running costs and does it seem remotely sustainable? I'm Kenyan too from the neigbouring Kitui county.. hit with similar challenges
  • 1
    Wouldn’t electrolysis of the water split it into hydrogen and oxygen? Isn’t there cation and anion scarcity?

    Why not use a distillation method where you can heat an elevated black tank or pan using mirrors?

    Servo controlled mirrors of course. :-D
  • 0
    Cooling could be done without elecricity probably? Windcatchers and similar things.
  • 2
    Why would you use electrolysys?!
    You are spliting molecules and that takes MAGNITUDES more of energy than just boiling it! In those situations you want simplicity NOT FUCKING IOT BULLSHIT. Imagine if your fancy pants system fails.... What then? Solar distillers are a thing already, just design something easy to maintain, cheap and without the need for electricity in the first place!
  • 0
    Thanks Gregozor2121
    4936
    ,i will consider that. Just that the scope of my study aimed at using technology in enhancing the process, its well understood. Thanks for your feedback
  • 0
    Hello @v3ctor ,thanks for the thought. It is part of my research and would like to make it come into action, i am still doing my research. The initial cold for my project would be 200,000Ksh with a return value of 200,000 anually per project setting
  • 0
    Big thanks @irene, thanks for the insights
  • 0
    Thanks alot, @Quirinus
Add Comment